How to Jailbreak iOS 9.2 thru 9.3.3 on Windows

Last updated on


This video covers in detail how to perform an iOS jailbreak for iOS versions 9.2 thru 9.3.3, using a Windows system. All 64-bit devices are supported, including: iPhone 6s, iPhone 6s Plus, iPhone 6, iPhone 6 Plus, iPhone SE, iPhone 5s, iPad Pro (12.9-inch), iPad Pro (9.7-inch), iPad Air 2, iPad Air, iPad mini 4, iPad mini 3, iPad mini 2, iPod touch (6th generation).

Follow the steps below to iOS jailbreak your device:

  1. Under “Settings” -> “Touch ID and Passcode”, turn off any touch IDs or passcodes that you have set. Also, be sure that “airplane mode” is NOT enabled.
  2. Log out of iCloud.
  3. Create a secondary “Apple ID” to use specifically for the iOS jailbreak procedure and then log out of it, as well.
  4. Download Pangu iOS 9.2 – 9.3.3 jailbreak: http://en.pangu.io.
  5. Once Pangu has downloaded, right-click it and choose “Run as administrator” and choose “Yes” to install. NOTE: You many need to temporarily disable your anti-virus software.
  6. Launch iTunes and backup your iOS device.
  7. Connect your iOS device to your computer via a USB cable.
  8. Launch PP (Pangu) application.
  9. Enter your secondary Apple ID and password and then click the green button to install the PP app on your iOS device.
  10. Once installed choose to “trust” the PP app.
  11. Launch the PP app and click “OK”.
  12. Once a circle appears, click it and lock your device.
  13. When you receive a “storage almost full” message, swipe to unlock your iOS device and the installation will begin. NOTE: Your iOS device will reboot twice during the process.
  14. Once your device has rebooted, swipe to unlock and you should see an app named “Cydia”. If so, your iOS jailbreak is complete!
  15. Be sure to re-enable your “Touch ID and Passcode”, under “Settings”.

Share it with your friends Like

Comments

Write a comment

*

Time limit is exhausted. Please reload CAPTCHA.